![]() I'm hoping that my half baked solution will help the experts to come up with a good solution.Īll the same, running lxde as root solves a lot of permissions problems when getting things set up. If your MicroSD card does not have enough room, you need to resize the main partition after the. The instructions I found - which were to edit files or set configuration options - were rather cryptic, the sort that only make sense if you already know what to do. Follow these steps to boot Fedora ARM on your Raspberry Pi. Using startx seems to require a run manager and one rdm (or something like that) seems to be installed. Google isnt very helpful with this, as I only find solutions or documentation for systems where a display is connected. If you can ssh into the Pi using Putty and the Pis IP address then sudo nano /etc/rc. I had also googled the results gave me the impression that there were two ways to start an ide, the runlevel method and by running startx. ![]() It seems to run everything but I suspect that it's running as root rather than as an official user. Does it behave as it should (able to launch programs etc)? Or does it ask for login details when you attempt to launch anything from LXDE? It does seem odd that you are able to log straight into LXDE without giving credentials. The problem is though, all search results are from 2005-07, so I dont know if all this config is still nessecary/valid in Debian 6 Squeeze. Pressing Alt-F1 through Alt-F12 will switch you one of them. The simple answer is to use one of the virtual consoles. ![]() I've been doing some googling, and I believe I need to install a login manager and change the runlevel to get the results i'm looking for. We’ve been asked how you might get access to the console to control the Pi if you don’t happen to have a network connection handy through which to SSH.
0 Comments
Leave a Reply. |